Soundmax SM-LCD810 Manuel d'utilisateur Page 10

  • Télécharger
  • Ajouter à mon manuel
  • Imprimer
  • Page
    / 24
  • Table des matières
  • MARQUE LIVRES
  • Noté. / 5. Basé sur avis des utilisateurs
Vue de la page 9
10
a. Color-Sys: select color system in your country as follows: AUTO, PAL,
N3.58, N4.43, SECAM.
b. Sound-Sys: Select appropriate sound system in your country as
follows: 5.5 m, 6.0 m, 6.5 m.
In the System menu, press CH +/- to select Sound system and press VOL
+/- to select appropriate sound system in your country.
c. Blue back: switch on this item. When the receiving signal is very low,
you will see the blue screen.
d. Horizontal: Press the [V+] or [V-] button to turn the picture up to
down.
e. Vertical: Press [V+] or [V-] button to turn the picture left to right.
Menu Preset
Press MENU to enter into menu Preset. Press CH +/- to select and press
VOL +/- to change setting.
a. Position: Please choose the number of channel you want to set.
b. Remember: Turn on to remember the set channel.
c. Band: You may choose the band where to search the channel. You can
choose
V-L, V-H, UHF.
d. Swap: Press CH +/- to choose the program swap item. The function
allows you to swap the current channel number to another one. Press CH
+/- to choose target channel (it means the channel has been chosen,
when the color of the channel number's change to red), press VOL +/- to
add or reduce the number, then press CH +/- to choose current channel
number, press VOL +/- to realize the function.
e. Fine: press CH +/- to choose this item, then press VOL +/-, you can
adjust the program conditions while you are watching by hand.
f. Search: press CH +/- to choose this item, then press VOL +/- to
proceed to search channels by hand.
g. Auto-Search: the original set is auto search, press VOL +/- to make it
auto search. It would search all the currently TV channels and store
them.
Caution:
1. When performing manual search, press VOL +/- can reverse the
searching direction. Press MENU to stop manual search.
2. Use CH +/- to select channel number. If a channel is preset, the
channel number will become red.
Note:
1. Hue setting applies to NTSC input only.
2. Volume can simply be adjusted by pressing VOL +/-.
3. OSD menu will automatically exit in 10 seconds.
Vue de la page 9
1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 23 24

Commentaires sur ces manuels

Pas de commentaire